Pioneer ANH-P10MP - Manual (Page 47)

04
Section
47
En
English
Tuner
Listening to the radio
These are the basic steps necessary to oper-
ate the radio. More advanced tuner operation
is explained starting on the next page.
Preset number indicator
Shows what preset has been selected.
LOC indicator
Shows when local seek tuning is on.
Stereo ( ) indicator
Shows that the frequency selected is being
broadcast in stereo.
Band indicator
Shows which band the radio is tuned to,
MW, LW or FM.
Frequency indicator
Shows to which frequency the tuner is
tuned
.
Operation
1 Press SOURCE until “Tuner” appears.
2 Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press BAND/ESC to select a band.
Press BAND/ESC until the desired band is
displayed, FM–1, FM–2, FM–3 for FM or MW/
LW.
4 To perform manual tuning, press or
with quick presses.
The frequencies move up or down step by
step.
5 To perform seek tuning, press and hold
or for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception
is found.
You can cancel seek tuning by pressing either
or briefly.
If you press and hold or you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Notes
• After choosing your destination, press INFO
and you can listen to the guide voice during
navigation guidance.
• When new traffic information arrives,
appears. If desired, check the new informa-
tion.