Pioneer ANH-P10MP - Manual (Page 12)

Before You Start
En
01
Section
12
Protecting your unit from
theft
The front panel can be detached from this
product and stored in the protective case pro-
vided to discourage theft.
Important
• Never use force or grip the display and the
buttons tightly when removing or attaching.
• Avoid subjecting the front panel to excessive
shocks.
• Keep the front panel out of direct sunlight
and high temperatures.
Removing the front panel
1 Press OPEN to open the front panel.
(Refer to Navigation unit on page 14.)
2 Grip the left side of the front panel
and pull it gently outward.
Take care not to grip it tightly or to drop it.
3 Put the front panel into the protective
case provided for safe keeping.
Attaching the front panel
Replace the front panel by holding it
upright to this product and clipping it se-
curely into the mounting hooks.
About the demo mode
This product features two demonstration
modes. One is the reverse mode, the other is
the feature demo mode.
• You cannot cancel a demo mode when the
front panel is open.
Important
The red lead (ACC) of this product should be
connected to a terminal coupled with ignition
switch on/off operations. If this is not done,
the vehicle battery may be drained.
Reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing
5 numbered button when
power to this product is turned off while the
ignition switch is set to ACC or ON cancels
the reverse mode. Pressing
5 numbered but-
ton again to start the reverse mode.
Feature demo
The feature demo automatically starts when
power to this product is turned off while the
ignition switch is set to ACC or ON. Pressing
6
numbered button during feature demo opera-
tion cancels the feature demo mode. Pressing