Pioneer ANH-P10MP - Manual (Page 56)

En
06
Section
56
Built-in CD Player
Playing a disc
These are the basic steps necessary to play a
disc with your built-in CD player. More ad-
vanced CD operation is explained starting on
the next page.
Track number indicator
Shows the track currently playing.
Play time indicator
Shows the elapsed playing time of the cur-
rent track.
Disc title (if exists)
Shows title of the disc currently playing.
Track title indicator (if exists)
Shows the title of the track currently play-
ing.
1 Press OPEN to open the front panel.
CD loading slot appears.
If a navigation CD is in the loading slot, press
the button and remove it.
After a CD has been inserted, press SOURCE
to select the built-in CD player.
The navigation CD must be inserted to start
the route calculation. During the calculation, the
prompt CD flashes on the display. Once the cal-
culation has been completed, the prompt CD ex-
tinguishes, the navigation CD can be removed
and an audio CD can be inserted.
Do not use with the front panel left open. If
the front panel is left open, it may result in
injury in the event of an accident.
2 Insert a CD into the CD loading slot.
Playback will automatically start.
You can eject a CD by pressing .
To avoid a malfunction, make sure that no
metal object comes into contact with the termi-
nals when the front panel is open.
3 Close the front panel.
4 Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
5 To perform fast forward or reverse,
press and hold or .
If you select the search method to “ Rough
search”, pressing and holding or enables
you to search every ten track in the current disc.
(Refer to
Selecting the search method on
page 60.)
6 To skip back or forward to another
track, press or .
Pressing skips to the start of the next track.
Pressing once skips to the start of the cur-
rent track. Pressing again will skip to the pre-
vious track.
CD loading slot
button