Deleting a stopover, Storing a specified destination in the, Destination memory – Pioneer ANH-P10MP User Manual
Page 39: Storing in the destination memory, Storing a, Navigation

02
Section
Navigation
39
En
English
4
To start route calculation to the stop-
over, select “START” and then press NAVI/
OK.
The route is calculated and route guidance
begins.
Notes
•
is displayed inversely during route
guidance to a stopover.
• When you reach the stopover, the message
“
YOU HAVE REACHED YOUR STOPOVER” is
displayed, and route guidance to the final
destination automatically starts.
Deleting a stopover
1
Press .
A confirmation message appears asking you
whether to delete the stopover.
2
To delete the stopover, press NAVI/OK
within 8 seconds.
The route is recalculated and route guidance
begins.
To continue route guidance with a stopover,
press
BACK.
Storing a specified
destination in the
destination memory
Destination memory saves repeated manual
entry, if the destination is required at a later
date. Refer to
Selecting a destination from the
Storing in the destination
memory
1
Specifying the location you want to
store by performing the same operation
as for the destination
Refer to
Entering the destination information
on page 23.
The route menu appears when you enter the
location information.
2
In the route menu, select “SAVE DESTI-
NATION” and press NAVI/OK.
3
If necessary, input the place-name.
Any name of your choice consisting of up to
20 characters can be entered for the specified
destination.
If you do not wish to enter a name of your
choice, press and hold
NAVI/OK for more than 2
seconds.