Asante Technologies 8000 - Manual (Page 24)

Installation and Setup
Page 2-6
3
Connect the Stack Matrix module on the first switch to
the Stack Connector modules on the other switches. Use
the 50-pin stacking cables provided by Asanté, as shown
in Figure 2-1.
K Note: Do not use any cable but the IntraCore 8000
stacking cable supplied with your unit. If you need
additional cables, contact Asanté support (see Appen-
dix A, “Technical Support,” for details).
Figure 2-1 Four stack configuration
When you have cabled the switches together, proceed with network cabling,
as described in “Connecting to the Network” earlier in this chapter.