Asante Technologies 3624/48 User Manual
Intracore, User’s manual
Table of contents
Document Outline
- IntraCore 3624/48
- Chapter 2: Hardware Installation and Setup
- Chapter 3: Initial Software Setup
- Chapter 4: Understanding the Command Line Interface (CLI)
- 4.1 User Top (User EXEC) Mode
- 4.2 Privileged Top (Privileged EXEC) Mode
- 4.3 Global Configuration Mode
- 4.4 Advanced Features Supported within the Command Mode
- 4.5 Using CLI Command History
- 4.6 Using Command-Line Editing Features and Shortcuts
- 5.1 Managing the System
- 5.2 Managing Configuration Files
- 5.3 Managing system image Files
- 5.4 Configuring SNMP
- 5.5 Spanning Tree Algorithm
- Chapter 6: Configuring IP
- 6.3 Access Lists
- Chapter 7: VLAN Configuration
- Chapter 9: Configuring the Switch Using the GUI
- 9.1 Main Configuration Menu
- 9.2 System
- Port Management – Port Config - Specific Port. Settings can be made on a per port basis. When a port number is clicked the subscreen appears.
- Port Management – LAG Group. Click on a group number to set the groups properties.
- VLAN MANAGEMENT – VLAN SETTINGS. With a vlan selected, ports can be marked as tagged, or untagged. Lover on the screen, LAG groups can also be tagged or untagged. Click Save Settings when done.
- MSTP. Multiple Spanning Tree Protocol can be enabled on this page.
- Chapter 10: CLI Commands
- Appendix A: Basic Troubleshooting
- Appendix C: FCC Compliance and Warranty Statements