RADWAG WTB 600/AU Carat Balance - Manual (Page 54)

21.2. A set of commands for RS interfaces
Commands Description of commands
Z Zero balance
T Tare balance
TO Give tare value
S Send stable measurement result in basic measuring unit
SI Immediately send measurement result in basic measuring unit
SU Send stable measurement result in current measuring unit
SUI Immediately send measurement result in current measuring unit
C1 Switch on continuous transmission in basic measuring unit
C0 Switch off continuous transmission in basic measuring unit
CU1 Switch on continuous transmission in current measuring unit
CU0 Switch off continuous transmission in current measuring unit
PC Send all implemented commands
Caution:
1. Each command must end with CR LF characters;
2. The best policy for communication is not sending another
command until the former answer has been received.
21.3. Responses format for commands sent from computer level
On receipt of a command, the terminal sends a response in one of the
following formats:
XX_A CR LF command understood and in progress
XX_D CR LF command carried out (appears only after the command XX_A)
XX_I CR LF command understood but not accessible at this moment
XX _ ^ CR LF command understood but max range is exceeded
XX _ v CR LF command understood but min range is exceeded
XX _ OK CR LF Command carried out (completed)
ES_CR LF Command not recognized
- 54 -