RADWAG WTB 600/AU Carat Balance - Manual (Page 44)

At the same time the test results can be printed on a connected printer
by pressing button .
16.9. Determining percent content of main metal in a tested alloy
Working mode MODE A enables determining percent content of main
metal in a 2 or 3 component alloy.
16.9.1. Mode’s local settings
Local settings of MODE A are grouped in submenu :
No.
Parameter
name Default
settings
Description
4.5.1 in ALL-2
Metal alloy selection (ALL-2: 2-components alloy,
ALL-3: 3-components alloy)
4.5.2 d1 - Density of main metal in an alloy
4.5.3 d2 - Density of subsidiary (second) metal in an alloy
4.5.4 d3 -
Density of subsidiary (third) metal in an alloy.
In case of alloy ALL-3.
4.5.5 rtA 5 : 5
% ratio of subsidiary metals in an alloy. In case of alloy
ALL-3. Available settings – 4:6, 5:5, 6:4, 7:3, 8:2
16.9.2. Testing procedure
• Select working mode
> in accordance with point 16.1 of this
user manual, after which the main window of selected working mode is
displayed:
• If measurement result is other than zero press
key (balance
zeroing).
- 44 -