RADWAG WTB 600/AU Carat Balance - Manual (Page 41)

• After the indication returns to ZERO place the tested sample in the
container with liquid (water) (weighing in liquid, flickering command
IN WATER) and on stabilization of measurement result press
key,
• Simultaneously, for approximately 2 seconds the software displays
liquid’s temperature value, and a window on process completion
appears (message END):
• The following test results are displayed on pressing
key.
Test results:
• Caratage of gold alloy* [K],
• Percent content of gold in tested alloy* [%],
• Density of tested sample [g/cm
3
],
• Volume of tested sample [cm 3
],
• Liquid
temperature [
°C],
• Mass of weighed sample in the air [g],
• Mass of weighed sample in liquid (water) [g].
*) – alloy type is set in parameter .
At the same time the test results can be printed on a connected printer
by pressing button .
16.8. Testing platinum class
Working mode MODE P enables testing one of two platinum alloys:
• Platinum with admixture of nickel (mode P-1),
• Platinum with admixture of palladium (mode P-2).
- 41 -