Determining density of other metals – RADWAG WTB 600/AU Carat Balance User Manual
Page 46
*) - alloy type is set in parameter
At the same time the test results can be printed on a connected printer
by pressing button
.
16.10. Determining density of other metals
Working mode MODE S enables determining density of other metals.
Procedure:
• Select working mode
>
in accordance with point 16.1 of this
user manual, after which the main window of selected working mode
is displayed:
• If measurement result is other than zero press
key (balance
zeroing).
• Load tested sample on the top weighing pan (weighing in the air,
flickering command IN AIR) and on stabilization of measurement
result press
key,
• Simultaneously the following command is displayed:
• Unload the tested sample from the top weighing pan,
- 46 -