Winland Electronics EA800-ip - Manual (Page 57)

D-011-0152 57
Specifications
Console and Sensor Specifications
The following table lists the specifications for the EA800 console, sensors, and accessories.
Table 14 Specifications
Item Specification
Dimensions Approximately 9.375” H x 8.125" W x 2.25" D (230 mm x 199 mm x 55 mm)
Weight
Console: 0.6 lb (0.27 kg)
Wireless Sensors: 0.26 lb (0.11 kg) with batteries
Mounting
The EA800 console is mountable directly to 3-gang standard electrical enclo-
sure using pre-drilled holes on the EA800 rear case.
The EA800 console and wireless sensors can be mounted to drywall or similar
surfaces using the appropriate anchors (not included).
Case Material ABS, UL94V-0 rated
EA800 Power Specification
(See Notes 1 and 2)
11 to 26VDC @ 500mA. Standard commercial filtered and regulated power
supply suitable. Supplied by AC adapter (not included; see Accessories) or
alarm panel.
Note: Power supply requirement does not include additional require-
ments for loads switched through alarm output relays where
power is derived from EA800 EA400 terminal strip connections.
EA800 Aux Power Out
Equivalent to DC input voltage used: 11 to 26VDC
(Maximum output current 0.5A).
EA800 Real-Time Clock Battery CR2032 (3V Cell)
Wireless Sensor
Power Specification
Either:
• 12 VDC @ 100mA using a 2.1 mm barrel plug, center positive; OR
• 2xAA Alkaline Batteries (1.5V Cell)
Wireless Sensor Radiating
Power (minimum, at PCB
antenna connector)
• EA800 console: -3.5 dBm
• Sensors: -2.5 dBm
Wireless Sensitivity:
(minimum at printed circuit
board antenna connection)
• EA800: -94.5 dBm
• Sensors: -95.5 dBm
Low and High Limit Adjust Range:
(Winland thermistor and humidity sensors only)
Temperature: -112° F to 302° F
(-80° C to 150° C)
Note: The Low and High Limit Adjust Range is dependent upon the
sensor being used. See “Temperature Sensors” on page 15.
Humidity: 5 to 95% RH
Note: The Low and High Limit Adjust Range is dependent upon the
sensor being used. See “Humidity Sensors” on page 16.
Water Presence: No Alarm / Alarm
Sensors
Up to four wired sensors
Up to four wireless sensors
Cable Length to Wireless
Multi-Function Sensor
EA-WMFS
100 ft. (30 m) maximum
Wired Temperature Sensor: 2-wire; maximum 1000 ft. (304 m) cabling length using 22 AWG minimum