Winland Electronics EA800-ip - Manual (Page 46)

46 D-011-0152
Changing the Time Format
Changing the Time Format
Note: The default time format is 24 HR.
To change the time format perform the following procedure:
Changing the Date or Time Setting
To change the date see “Configuring System Parameter Settings” on page 28. If your region uses Daylight Savings
Time and you want the EA800 to display the correct time, you must change the time setting manually when
Daylight Savings Time starts and ends. See “Configuring System Parameter Settings” on page 28.
Changing Sensor Data Collection Frequency
Note: The default collection frequency is 5 Minutes. See Table 4 on page 13 for information on correlating data
collection frequency to the number of data points collected.
To set the data collection frequency perform the following procedure:
F3
Unlock the EA800 as shown
in “Locking and Unlocking
the EA800” on page 41
F3
Unlock the EA800 as shown
in “Locking and Unlocking
the EA800” on page 41
F3
Unlock the EA800 as shown
in “Locking and Unlocking
the EA800” on page 41