Winland Electronics EA800-ip - Manual (Page 34)

34 D-011-0152
Configuring the Relays
Configuring the Relays
When all sensors have been added, you may change the default relay configurations. If the defaults are
acceptable, it is not necessary to configure the relays. Perform the following procedure to configure all relays used:
Note: The default relay settings are:
• Relays 1-8 (Active Condition = Alarm Only);
• Aux Relay (Active Condition = Alarm or Warning);
• All Relays (No Alarm - Relay State = De-Energized)
OR
F3
OR
F3
OR
Repeat this procedure to configure the next relay.
Return to the Home screen when you have configured all
relays.
To create a backup copy of the complete configuration, see
“Saving Configuration Settings” on page 51.
F3