Adding wireless sensors – Winland Electronics EA800-ip User Manual
Page 29
Installation
D-011-0152
29
Adding Wireless Sensors
1.
Unlock the console if necessary to continue programming. See “Accessing the MAIN MENU for Programming”
2.
Select
SENSORS from the MAIN MENU and follow the steps in the following diagram.
3.
After you press the ENTER key, the
NEW WIRELESS SENSOR screen is displayed. The EA800 searches for new
wireless sensors, indicated by an arrow that moves from left to right across the screen. When an available
wireless sensor has been detected, it is listed in the
SELECT SENSOR screen as shown below.
4.
Confirm that all new (unprogrammed) wireless sensors are displayed on the
SELECT SENSOR screen, use the
arrow keys to select the sensor to be configured, then follow the prompts to configure all screens for that
sensor.
Note:
To enter numeric values, use the arrow keys. To advance the cursor to the next digit when entering
numeric values, press the NEXT soft key (F3). To return to a previous digit, press the PREV soft key
(F2).
The Hysteresis setting helps prevent alarms from being set and reset continually if the environment is at or near
the alarm set point by providing an acceptable variance. For example, if
HYSTERESIS is set at 1 and the sensor High
Alarm Limit is set at +158, the sensor reading must decrease to +157 (+158 minus 1) in order for the alarm condition
to reset to a no-alarm condition.