Editing sensor parameters – Winland Electronics EA800-ip User Manual

Page 44

D-011-0152

Editing Sensor Parameters

The general procedure for editing sensor parameters is provided below. Not all sensor parameters can be edited

for an installed sensor. The editable parameters are dependent on the installed sensor, so the

EDIT SENSOR screen

varies according to the sensor selected. You cannot edit the following:

■

The low and high scaled values for a 4-20mA sensor. If these require changes, you must delete the 4-20mA
sensor and re-add it to the system. See “Adding a 4-20mA Sensor” on page 33.

■

A sensor’s type. For example, if a 4-20mA sensor was incorrectly added as a Blue temperature sensor, you
must delete the incorrect sensor and then re-add the correct sensor.

■

The unit of measure. If unit of measure must be changed, the sensor must be deleted and re-added to the system.

Unlock the EA800 as
shown in “Locking and
Unlocking the EA800” on
page 41

Select the sensor to edit.

Select the parameter to be edited.

Use PREV, NEXT, and arrow keys to change value
as required.

To edit another
parameter

when done
editing

to lock