Changing the buzzer setting – Winland Electronics EA800-ip User Manual
Page 47
Maintenance
D-011-0152
47
Changing the Buzzer Setting
Note:
The default buzzer configuration is
ENABLED and the active condition of the on-board buzzer mirrors what
is assigned to the Auxiliary Relay.
To change the buzzer setting perform the following procedure:
WARNING
!
Changing the buzzer setting to DISABLED turns off the audible alarm tone from
the console. Do not disable the buzzer unless you are sure you do not want the
console to emit an audible tone when an alarm occurs. The active condition of the
buzzer mirrors what is assigned to the auxiliary relay.
Unlock the EA800 as shown
in “Locking and Unlocking
the EA800” on page 41
F3