Accton Technology ES5508 - Manual (Page 417)

IP Interface Commands
4-205
4
Example
The following shows how to configure port 1 as a multicast router port within VLAN 1:
show ip igmp snooping mrouter
This command displays information on statically configured and dynamically learned
multicast router ports.
Syntax
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
Displays multicast router ports for all configured VLANs.
Command Mode
Privileged Exec
Command Usage
Multicast router port types displayed include Static.
Example
The following shows that port 11 in VLAN 1 is attached to a multicast router:
IP Interface Commands
An IP addresses may be used for management access to the switch over your
network. The IP address for this switch is obtained via DHCP by default. You can
manually configure a specific IP address, or direct the device to obtain an address
from a BOOTP or DHCP server when it is powered on. You may also need to a
establish a default gateway between this device and management stations or other
devices that exist on another network segment.
Basic IP Configuration
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/1
Console(config)#
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
Console#
Table 4-72 Basic IP Configuration Commands
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-206
ip default-gateway Defines the default gateway through which an in-band
management station can reach this device
GC 4-207