Accton Technology ES5508 - Manual (Page 340)

Command Line Interface
4-128
4
disabled, you must manually specify the link attributes with the speed-duplex
and flowcontrol commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signal configuration will
also be disabled for the RJ-45 ports.
Example
The following example configures port 9 to use autonegotiation.
Related Commands
capabilities (4-128)
speed-duplex (4-126)
capabilities
This command advertises the port capabilities of a given interface during
autonegotiation
31 . Use the no form with parameters to remove an advertised
capability, or the no form without parameters to restore the default values.
Syntax
[no] capabilities {100full | 100half | 10full | 10half | flowcontrol |
symmetric}
• 100full - Supports 100 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 10half - Supports 10 Mbps half-duplex operation
Default Setting
100BASE-TX: 10half, 10full, 100half, 100full
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When auto-negotiation is enabled with the negotiation command, the switch
will negotiate the best settings for a link based on the capabilites command.
When auto-negotiation is disabled, you must manually specify the link
attributes with the speed-duplex command.
Example
The following example configures Ethernet port 9 capabilities to 100half and 100full.
Console(config)#interface ethernet 1/9
Console(config-if)#negotiation
Console(config-if)#
31. The settings for this parameter cannot be changed.
Console(config)#interface ethernet 1/9
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#