Accton Technology ES5508 - Manual (Page 341)

Interface Commands
4-129
4
Related Commands
negotiation (4-127)
speed-duplex (4-126)
shutdown
This command disables an interface. To restart a disabled interface, use the no
form.
Syntax
[no] shutdown
Default Setting
All interfaces are enabled.
Command Mode
Interface Configuration (Ethernet Ports 1-8, Port Channel)
Command Usage
This command allows you to disable a port due to abnormal behavior
(e.g., excessive collisions), and then reenable it after the problem has been
resolved. You may also want to disable a port for security reasons.
Example
The following example disables port 5.
switchport broadcast packet-rate
This command configures broadcast storm control. Use the no form to disable
broadcast storm control.
Syntax
switchport broadcast packet-rate rate
no switchport broadcast
rate - Threshold level as a rate; i.e., packets per second.
(Range: 1042-262143)
Default Setting
• Enabled
• Packet-rate limit: 1042 pps
Command Mode
Interface Configuration (Ethernet Ports 1-8)
Command Usage
• When broadcast traffic exceeds the specified threshold, packets above that
threshold are dropped.
• Broadcast control does not effect IP multicast traffic.
Console(config)#interface ethernet 1/5
Console(config-if)#shutdown
Console(config-if)#