beautypg.com

Snmp-server location, Snmp-server host – Accton Technology ES5508 User Manual

Page 326

background image

Command Line Interface

4-114

4

Related Commands

snmp-server location (4-114)

snmp-server location

This command sets the system location string. Use the no form to remove the
location string.

Syntax

snmp-server location text
no snmp-server location

text - String that describes the system location.
(Maximum length: 255 characters)

Default Setting

None

Command Mode

Global Configuration

Example

Related Commands

snmp-server contact (4-113)

snmp-server host

This command specifies the recipient of a Simple Network Management Protocol
notification operation. Use the no form to remove the specified host.

Syntax

snmp-server host host-addr [inform [retry retries | timeout seconds]]

community-string [version {1 | 2c | 3 {auth | noauth | priv} [udp-port port]}

no snmp-server host host-addr

host-addr - Internet address of the host (the targeted recipient).

(Maximum host addresses: 5 trap destination IP address entries)

inform - Notifications are sent as inform messages. Note that this option is

only available for version 2c and 3 hosts. (Default: traps are used)
- retries - The maximum number of times to resend an inform message if

the recipient does not acknowledge receipt. (Range: 0-255; Default: 3)

- seconds - The number of seconds to wait for an acknowledgment before

resending an inform message. (Range: 0-2147483647 centiseconds;
Default: 1500 centiseconds)

community-string - Password-like community string sent with the

notification operation to SNMP V1 and V2c hosts. Although you can set this
string using the snmp-server host command by itself, we recommend that
you define this string using the snmp-server community command prior

Console(config)#snmp-server location WC-19
Console(config)#