Accton Technology ES5508 - Manual (Page 328)

Command Line Interface
4-116
4
To send an inform to a SNMPv3 host, complete these steps:
1. Enable the SNMP agent (page 4-111).
2. Allow the switch to send SNMP traps; i.e., notifications (page 4-116).
3. Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.
4. Create a view with the required notification messages (page 4-119).
5. Create a group that includes the required notify view (page 4-120).
6. Specify a remote engine ID where the user resides (page 4-117).
7. Then configure a remote user (page 4-122).
• The switch can send SNMP Version 1, 2c or 3 notifications to a host IP
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the SNMP
version, the default is to send SNMP version 1 notifications.
• If you specify an SNMP Version 3 host, then the community string is
interpreted as an SNMP user name. If you use the V3 “auth” or “priv” options,
the user name must first be defined with the snmp-server user command.
Otherwise, the authentication password and/or privacy password will not
exist, and the switch will not authorize SNMP access for the host. However, if
you specify a V3 host with the “noauth” option, an SNMP user account will be
generated, and the switch will authorize SNMP access for the host.
Example
Related Commands
snmp-server enable traps (4-116)
snmp-server enable traps
This command enables this device to send Simple Network Management Protocol
traps or informs (i.e., SNMP notifications). Use the no form to disable SNMP
notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure notifications.
• link-up-down - Keyword to issue link-up or link-down notifications.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Console(config)#snmp-server host 10.1.19.23 inform retries 10 timeout 30
batman version 2c udp-port 162
Console(config)#