Accton Technology ES5508 - Manual (Page 380)

Command Line Interface
4-168
4
show spanning-tree mst configuration
This command shows the configuration of the multiple spanning tree.
Command Mode
Privileged Exec
Example
VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Editing VLAN Groups
Console#show spanning-tree mst configuration
Mstp Configuration Information
--------------------------------------------------------------
Configuration name: R&D
Revision level:0
Instance Vlans
--------------------------------------------------------------
1 2
Console#
Table 4-55 VLAN Commands
Command Groups Function Page
Editing VLAN Groups Sets up VLAN groups, including name, VID and state 4-168
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
4-170
Displaying VLAN
Information
Displays VLAN groups, status, port members, and MAC addresses 4-175
Configuring Private VLANs Configures private VLANs, including uplink and downlink ports 4-177
Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol 4-178
Table 4-56 Editing VLAN Groups
Command Function Mode Page
vlan database Enters VLAN database mode to add, change, and delete
VLANs
GC 4-169
vlan Configures a VLAN, including VID, name and state VC 4-169