Accton Technology ES5508 - Manual (Page 136)

Configuring the Switch
3-96
3
CLI – The following example configures LACP parameters for ports 1-6. Ports 1-4
are used as active members of the LAG, ports 5 and 6 are set to backup mode.
Console(config)#interface ethernet 1/1 4-125
Console(config-if)#lacp actor system-priority 3 4-140
Console(config-if)#lacp actor admin-key 120 4-141
Console(config-if)#lacp actor port-priority 128 4-142
Console(config-if)#exit
.
.
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp actor system-priority 3
Console(config-if)#lacp actor admin-key 120
Console(config-if)#lacp actor port-priority 512
Console(config-if)#end
Console#show lacp sysid
4-143
Channel Group System Priority System MAC Address
-------------------------------------------------------------------------
1 3 00-00-E9-31-31-31
2 32768 00-00-E9-31-31-31
3 32768 00-00-E9-31-31-31
.
.
.
Console#show lacp 1 internal
4-143
Port channel: 1
-------------------------------------------------------------------------
Oper Key:
120
Admin Key: 0
Eth 1/ 1
-------------------------------------------------------------------------
LACPDUs Internal: 30 sec
LACP System Priority: 3
LACP Port Priority:
128
Admin Key: 120
Oper Key: 120
Admin State: defaulted, aggregation, long timeout, LACP-activity
Oper State:
distributing, collecting, synchronization,
aggregation, long timeout, LACP-activity
.
.
.