Accton Technology ES5508 - Manual (Page 288)

Command Line Interface
4-76
4
show tacacs-server
This command displays the current settings for the TACACS+ server.
Default Setting
None
Command Mode
Privileged Exec
Example
Port Security Commands
These commands can be used to enable port security on a port. When using port
security, the switch stops learning new MAC addresses on the specified port when it
has reached a configured maximum number. Only incoming traffic with source
addresses already stored in the dynamic or static address table for this port will be
authorized to access the network. The port will drop any incoming frames with a
source MAC address that is unknown or has been previously learned from another
port. If a device with an unauthorized MAC address attempts to use the switch port,
the intrusion will be detected and the switch can automatically take action by
disabling the port and sending a trap message.
Console#show tacacs-server
Remote TACACS server configuration:
Server IP address: 10.11.12.13
Communication key with TACACS server: *****
Server port number:
49
Console#
Table 4-31 Port Security Commands
Command Function Mode Page
port security Configures a secure port IC 4-77
mac-address-table static Maps a static address to a port in a VLAN GC 4-147
show mac-address-table Displays entries in the bridge-forwarding database PE 4-148