Allied Telesis AT-WR4500 - Manual (Page 60)

60 AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
RouterOS v3 Configuration and User Guide
Property Description
channel-time (time; default: 200ms) - how long to snoop each channel, if multiple-channels is set to yes
multiple-channels (yes | no; default: no) - whether to snoop multiple channels or a single channel
no - wireless snooper snoops only one channel in frequency that is configured in /interface wireless
yes - snoop in all channels that are listed in the scan-list in /interface wireless
receive-errors (yes | no; default: no) - whether to receive packets with CRC errors
Command Description
snoop - starts monitoring wireless channels
wireless interface name - interface that monitoring is performed on
BAND - operating band
Example
Snoop 802.11b network:
[admin@AT-WR4562] interface wireless snooper> snoop wlan1
BAND FREQ USE BW NET-COUNT STA-COUNT
2.4ghz-b 2412MHz 1.5% 11.8kbps 2 2
2.4ghz-b 2417MHz 1.3% 6.83kbps 0 1
2.4ghz-b 2422MHz 0.6% 4.38kbps 1 1
2.4ghz-b 2427MHz 0.6% 4.43kbps 0 0
2.4ghz-b 2432MHz 0.3% 2.22kbps 0 0
2.4ghz-b 2437MHz 0% 0bps 0 0
2.4ghz-b 2442MHz 1% 8.1kbps 0 0
2.4ghz-b 2447MHz 1% 8.22kbps 1 1
2.4ghz-b 2452MHz 1% 8.3kbps 0 0
2.4ghz-b 2457MHz 0% 0bps 0 0
2.4ghz-b 2462MHz 0% 0bps 0 0
[admin@AT-WR4562] interface wireless snooper>
4.3.21
Application Examples
Station and AccessPoint
This example shows how to configure 2 RouterOS routers - one as Access Point and the other one as a
station on 5GHz (802.11a standard).
Interface: To-AP
IP: 10.1.0.2
Interface: AP
IP: 10.1.0.1
Access Point
Station
Figure 5: Station and AP mode example
•
On Access Point:
• mode=ap-bridge
•
frequency=5805
• band=5ghz
•
ssid=test