Beijer Electronics SCOM RBC EN - Manual (Page 58)

Command Reference
58 Beijer Electronics, MAEN993
5.6.25 LAU_STATUS_DISPLAYADR (0x0302)
Current Device Address
Returns the current device address. If the DIL (DIP) switch settings are used, this is
the address configured via DIL switches. The group bits within the address field are
always set to 0. If the DIL switch settings are overridden, this is the configured device
address.
Supported since Firmware Version
LAUER RBC: 0.0.0.1
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Read the current device address (including group) from the device at address 14.2
(group 14, address 2):
As expected, according to the data returned by the device at address 14.2 (group 14,
address 2), the devices current address is 14.2:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x03 0x02 ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0...239 (0x00...0xEF)
Type: Byte
Length: 1
Description: Current combined device group and address
0 1 2 3 4 5 6 7...8 9
0x07 0xE2 0x4C 0x41 0x55 0x02 0x32 0x03 0x02 0xFA
0 1 2 3 4 5 6 7 8
0x06 0xE2 0x4C 0x41 0x55 0x01 0x34 0xE2 0x1D