Beijer Electronics SCOM RBC EN - Manual (Page 46)

Command Reference
46 Beijer Electronics, MAEN993
5.6.18 LAU_CONFIG_SETSTARTUPBRIGHTNESS
MODE (0x01A4)
Startup Brightness Mode
The Beijer Electronics RBCs can be configured to start with different levels of bright-
ness. There are four modes for the backlight at startup:
• Backlight is off
• Backlight has the same level as before it was turned off
• Backlight starts with the default brightness, which can be configured as well
• Backlight is on with maximum brightness
Supported since Firmware Version
LAUER RBC: 0.0.0.1
Command Stream
Response Message (Acknowledge)
Note:
The changes made by this command will become active only after a restart of the de-
vice.
0 1 2 3 4 5 6 7...9 10
0x07 ADR 0x4C 0x41 0x55 0x03 ICHKH 0x01 0xA4 Param ICHKD
Param
Value: 0x00: Device starts with minimum brightness (normally
backlight off)
0x01: Device starts with the same brightness as before it was
turned off
0x02: Device starts with default brightness
0x03: Device starts with maximum brightness
Type: Byte
Length: 1
Description: Set the mode of the backlight at startup
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0x00: Device starts with minimum brightness (normally
backlight off)
0x01: Device starts with the same brightness as before it was
turned off
0x02: Device starts with default brightness
0x03: Device starts with maximum brightness
Type: Byte
Length: 1
Description: Indicates at which level the backlight is set to at startup