17 lau_config_setremotecontrol (0x019c), Lau_config_setremotecontrol (0x019c) – Beijer Electronics SCOM RBC EN User Manual
Page 44

Command Reference
44
Beijer Electronics, MAEN993
5.6.17 LAU_CONFIG_SETREMOTECONTROL
(0x019C)
Remote Control Configuration
This command returns a configuration value that indicates whether the device is con-
figured to act as a remote controller. Beijer Electronics RBCs can be used as passive
devices, but can be additionally set up as remote controller devices to alter the back-
light level of any other device within the network every time the backlight is changed
by the buttons on the front of the device.
Supported since Firmware Version
LAUER RBC: 0.0.0.1
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Note:
The changes made by this command will become active only after a restart of the de-
vice.
0
1
2
3
4
5
6
7...9
10
0x07
ADR
0x4C
0x41
0x55
0x03
ICHKH 0x01
0x9C
Param ICHKD
Param
Value:
0x00: Disable remote controlling capability
0x01: Enable remote controlling capability
Type:
Byte
Length:
1
Description: Decides if the device is used also as remote controller
0
1
2
3
4
5
6
7
8
0x06
ADR
0x4C
0x41
0x55
0x01
ICHKH
Ret
ICHKD
Ret
Value:
0x00: Remote controlling capability is disabled
0x01: Remote controlling capability is enabled
Type:
Byte
Length:
1
Description: Indicates whether the device is used also as remote controller