11 lau_config_getdefaultbrightness (0x0126), Lau_config_getdefaultbrightness (0x0126) – Beijer Electronics SCOM RBC EN User Manual
Page 34

Command Reference
34
Beijer Electronics, MAEN993
5.6.11 LAU_CONFIG_GETDEFAULTBRIGHTNESS
(0x0126)
Startup Brightness Mode
For the Beijer Electronics RBCs a default brightness can be stored. This brightness is
used in two cases:
1. To set the display to this brightness when both buttons (brighter and darker) on
the front unit are pressed for about 1 second.
2. When the device is turned on and the startup brightness mode is set to default
brightness.
Supported since Firmware Version
LAUER RBC: 0.0.0.1
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Get the default brightness of the device at address 0.7 (group 0, address 7):
The default brightness of the device at address 0.7 (group 0, address 7) is returned:
0
1
2
3
4
5
6
7...8
9
0x07
ADR
0x4C
0x41
0x55
0x02
ICHKH 0x01
0x26
ICHKD
0
1
2
3
4
5
6
7
8
0x06
ADR
0x4C
0x41
0x55
0x01
ICHKH
Ret
ICHKD
Ret
Value:
0...255
Type:
Byte
Length:
1
Description: Returns the default brightness
0
1
2
3
4
5
6
7...8
9
0x07
0x07
0x4C
0x41
0x55
0x02
0x0D
0x01
0x26
0xD8
0
1
2
3
4
5
6
7
8
0x06
0x07
0x4C
0x41
0x55
0x01
0x0F
0x22
0xDD