Pulsafeeder MPC - Manual (Page 52)

15. Factory Default Values
Parameter Factory Set Value
Digital Input #1 INACTIVE, normally closed
Digital Input #2 INACTIVE, normally closed
Analog Input #1 INACTIVE
Analog Input #2 NOT AVAILABLE this revision
Digital Output #1 STROKE Indication, normally closed
Digital Output #2 AUTO/MANUAL Indication, normally closed
Digital Output #3 Alarm Indication, normally closed
Security Code Default = 0000
Language ENGLISH
MODE Local (Manual)
UNITS GPH (gallons per hour)
16. Retrieval of Setup Information
Users can access the system setup: information menu, which will list the
following data, this may be helpful in troubleshooting:
 Controller software revisions
 Pump serial number
 MPC model number
 Pump maximum flow
 Pump maximum speed
17. Special Keypress Access
In This SCREEN Press MENU and ENTER at the same time to:
SETPT XX.XXX
FLOW XX.XXX
View the stroke position of the pump
MENU
ANALOG I/O
Show calibration and RAW data for analog inputs
MENU
DIGITAL I/O
Shows current status of digital inputs and outputs
Press DOWN arrow to see digital out #3
Press the MENU key to exit from any of these special screens.