Pulsafeeder MPC - Manual (Page 14)

8. Installation and Wiring
8.1 Location
Review the Safety section prior to installing the MPC. It contains
information required to properly install and operate the MPC in an
industrial environment.
The site selected for the installation of your MPC is largely dependent on
that of the metering pump. Review the Installation, Operation, and
Maintenance manual provided with your metering pump. It details system
related issues that are important to proper operation of the pump.
Consider the following MPC related issues when selecting a site. Avoid
locations where the MPC would be subjected to extreme cold or heat.
The installation of this device must comply with national, state and local
codes.
Approximately 6 in (150 mm) of clearance should be maintained around
all 4 sides of the MPC.
No special services (e.g. air, liquid cooling) are required. Negligible
sound is emitted by the MPC - therefore, no special precautions are
necessary.
The MPC controller must be secured to an appropriate support before
use. Use four 3/8” (M8) bolts or anchors to secure the MPC controller
and pump to a fixed base. No assembly is required for the MPC
controller itself.
Figure 1 – Typical Installation.