Pulsafeeder MPC - Manual (Page 11)

6. Transport and Storage
6.1 Consignment receipt and unpackaging
Immediately after receipt of the equipment it must be checked against
the delivery/shipping documents for its completeness and that there has
been no damage in transportation.
Check any crate, boxes or wrappings for any accessories or spare parts
that may be packed separately with the equipment or attached to side
walls of the box or equipment.
Each product has a unique serial number. Check that this number
corresponds with that advised and always quotes this number in
correspondence as well as when ordering spare parts or further
accessories.
Shortages or damage should be reported immediately to the carrier and
your Pulsafeeder Representative.
6.2 Handling
Boxes, crates, pallets or cartons may be unloaded using fork lift vehicles
or slings dependent on their size and construction.
6.3 Lifting
A crane must be used for all controller/pump sets in excess of 25 kg (55
lb). Fully trained personnel must carry out lifting, in accordance with local
regulations.
Slings, ropes and other lifting gear should be positioned where they
cannot slip and where a balanced lift is obtained.
6.4 Recycling and end of product life
At the end of the service life of the product or its parts, the relevant
materials and parts should be recycled or disposed of using an
environmentally acceptable method and local requirements. If the
product contains substances that are harmful to the environment, these
should be removed and disposed of in accordance with current
regulations. This also includes the liquids and/or gases that may be used
in the "seal system" or other utilities.