Pulsafeeder MPC - Manual (Page 31)

10. Input/Output Setup
Use the “DIGITAL I/O” menu to activate the functions required for the intended
application.
Users may also reference Section 14 – Menu Maps for additional configuration
assistance
10.1 Analog Input Setup
Use the “ANALOG I/O” menu to activate the analog input signal function.
The menu can be used to set the analog input to either ACTIVE or
INACTIVE.
10.2 Digital Input Setup
Each of the 2 Digital INPUTS can be selected as:
Inactive
Leak Detection
Tank Level Input
Remote ON/OFF Input
Flow Detection (delay time
must be set)
Each can be set as normally OPEN or normally CLOSED. For example,
if an input is set to ON/OFF and NORMALLY CLOSED, this means a
CLOSED switch will activate the pump. A NORMALLY OPEN setup will
give the opposite response.
10.3 Analog Output Setup
Use the “ANALOG I/O” menu to activate the analog output signal
function.
The menu can be used to set the analog output to either ACTIVE or
INACTIVE.
10.4 Digital Output Setup
Each of the 3 Digital OUTPUTS can be selected as:
Inactive
ON/OFF Status
AUTO/MAN Status
Stroke Indicator (Pulse Output)
Alarm Indicator
Leak Detection Status
Tank Level Status