Pulsafeeder MPC - Manual (Page 5)

v
Conventions
For the remainder of this bulletin, the following Conventions are in effect.
A WARNING DEFINES A CONDITION THAT COULD CAUSE DAMAGE TO BOTH
THE EQUIPMENT AND THE PERSONNEL OPERATING IT . T HIS MANUAL MUST
BE CONSULTED IN ALL CASES WHERE THE W ARNING S YMBOL IS MARKED
IN ORDER TO FIND OUT THE NATURE OF THE POTENTIAL HAZARDS AND
ANY ACTIONS WHICH HAVE TO BE TAKEN TO AVOID THEM .
CAUTION, POSSIBILITY OF ELECTRIC SHOCK AND/OR
ELECTROCUTION HAZARD!
Notes are general information meant to make operating the
equipment easier.
Tips have been included within this bulletin to help the operator
run the equipment in the most efficient manner possible. These
“Tips” are drawn from the knowledge and experience of our
staff engineers, and input from the field.
Revision History:
Rev E (3-25-05)
- Section 3.1 Description, added 3-phase vs. single-phase info
- Change description of digital output specification
- New figure 2 (pump mounting)
- Updated analog in, analog out, and flow calibration instructions
- Update error handling text, Section 11
- Add specifications for voltage range and ELCB’s
- Add safety warnings about inrush current and capacitor discharge
throughout
Rev F (7-25-06)
- Added nametag diagram and note on proper input voltage selection
on page 9
- Added section 8.5 on adjusting motor base frequency
- Added sample digital output diagram in section 5.3.4
Rev H (9-26-07)
- Added clarification on digital output capability, sections 1.2, 5.3.4,
and 7.4
- Motor information added, sections 1.2, 1.3, and 11
- Added missing step in calibration instructions, section 8.1.1
Rev I (05-22-2014)
− Updated to reflect requirements of UL 61010-1 3 rd
Edition