Lyntec RPC - Manual (Page 5)

139-0498-01.5 5
Chapter One--Overview
This bulletin explains how to install and operate the LynTec
Remote Power Controller (RPC). The controller uses remotely
operated circuit breakers to control up to 167 remotely
operated branch circuits. Control signals originate externally
from commands received via the communications network or
from dry contact inputs. Acceptable communications protocols
include TCP/IP, RS-232, and DMX-512. RS-485 optional. OVERVIEW
Chapter 1--Introduction
CONTENTS Each RPC comes standard with the following components
installed:
• RPC Controller
• Power Supply
• Capacitive Buff er
• Isolated technical ground
• 15A unmotorized breaker
• Voltage Transducer
Optional additional components include:
• I/O expansion board
• Multi-panel expansion board
Introduction