Lyntec RPC - Manual (Page 25)

139-0498-01.25 25
Chapter Five--Control Setup
Network setup
Figure 5-2--Network Settings Figure 5-2 shows the network settings portion of the Network
setup.
Basic date and time information will be displayed in the Clock
Set fi elds. Verify that the year, month and day are correct. Set the
hour to the appropriate time for your time zone and verify that
the minute displayed is correct. Save this information by clicking
the Update Information button below the Clock Set portion of
the window.
Click the radio buttons for any pages to be printed out under the
Printable Pages header. To print the Network Setup, Panel Setup
or Panel Schedules pages at any time, ensure the desired buttons
have been selected and then click the Print Pages button to the
right. Please print a copy for your records after setup is complete.
The left hand side of the screen shows the current network
values. It is recommended that the user consult with the
network administrator before changing these values.
The IP, Subnet and Gateway addresses are only used in the
following situations:
• When DHCP is disabled
• When DHCP is enabled, but there is no DHCP server available
on the network
• For the network bootloader
If DHCP is enabled and available on the network, all these values
will be obtained from the DHCP server.