Lyntec RPC User Manual
Page 48
139-0498-01.48
Appendix B
48
Request event status
0xB0, 0xBC, 0xF0
Reply to activate/deactivate event command: status of
updated events
0xB0, 0xCA, event_address_i, event_status_i, < event_address_j,
event_status_j>, 0xF0
event_address_i, event_status_i, < event_address_j, event_
status_j>– addresses and status of events updated by the
command reply is generated for
Reply to request event status command: status of all 2
events
0xB0, 0xBC, status_byte, 0xF0
status_byte: bits 3-2: status of event #2, bits 1-0: status of event
#1
Event status description (1 bit)
Value
1
2
3
Status
Off On
Processing
Beacon request
“AMX\r”
Beacon
“AMXB<-SDKClass=Utility><-Make=Lyntec><-Model=RPC><-
Revision=1.1.4>\r”
(rev changed from 1.1.3; 1.1.3 supported old protocol)
If system is in Emergency Override mode, it replies to breaker,
zone or event on/off command with emergency override
response
0xB0, 0xCB, 0xF0
Device Discovery
Emergency override response
to breaker, zone, or event on/off
command