Lyntec RPC - Manual (Page 24)

139-0498-01.24
Chapter Five--Control Setup
24
Setup
SETUP HOME
To set the username and password for your panel, click
the Setup tab. The Setup Home tab should be displayed.
The default username displayed should be “admin” and the
password fi elds should be “pw”. Enter the desired username
in the fi rst fi eld, password in the second and then retype the
password again in the third fi eld. When ready, click the Update
Login Info button to save the changes to Controller memory.
Contact information for service can also be entered on this
page. Under the Serial Number fi eld, enter the name and
phone number of the installing contractor (Electrician) and the
system integrator (A/V Technician) for future reference. Save
this information by clicking the Update Information button
below the Clock Set portion of the window.
Figure 5-1--Setup Home
This section will guide you through the process of setting up yur
RPC Controller. First enter the IP address or NetBios name into
your web browser. When the RPC screen pulls up. Select “Setup”
and “SetupHome” Tabs.