Nikon S810c - Manual (Page 144)

Re
ference
S
ec
ti
o
n
E 18
5
Wait for the camera to detect the
smart device.
• When using an iOS smart device, the “Activate
Wi-Fi and select the camera SSID.” message is
displayed on the smart device. On the smart
device, switch to the home screen, turn on the
Wi-Fi (wireless LAN), and select the network
SSID that is displayed on the camera screen.
After the settings are complete, return to the
Connect to S810c application screen on the
smart device.
• When the camera detects the smart device, the
authentication screen is displayed.
6
Confirm that the identification
numbers match, and tap OK on the
camera screen and the smart device
screen.
• When using an iOS smart device, the Install
Profile screen is displayed. Install the profile.
- If JavaScript is disabled, the settings cannot
be completed. Enable JavaScript in the
default browser application.
- If the profile installation is canceled before
completion, perform the simple setup
procedure again.
- If the settings are not completed properly,
uninstall the profile and install it again.
7
Tap OK on the completion confirmation screen.
B
Notes About Simple Setup
Multiple connection settings cannot be saved. You must reconfigure the settings
each time you connect to a different smart device. To reconfigure the previous
connection settings when using an iOS 4.x smart device, uninstall the previously
installed camera profile before performing the simple setup procedure again.
Simple setup
Upload to smart device
15:30
Searching…
SSID: NikonADxxxxxxxxxxx
Cancel
OK
Simple setup
Upload to smart device
Confirm that the number displayed by the
smart device matches the 4-digit number
displayed below.
15:30