Blodgett CNVX-14E - Manual (Page 19)

15
Installation
adjustments
Before applying power to the appliance for the first time,
check for the following conditions:
• All electrical safety provisions have been adhered
to and the electrical connections are correct.
• Water is connected, turned on and all of the connec-
tions are water tight.
• The pan holders are inserted into the oven cavity.
• Cardboard has been removed from oven cavity.
• Gas has been turned on, if gas unit.
dOOR adJUSTMENT
The door catch may be adjusted in and out using the fol-
lowing procedure:
1. Flip the rubber boot on the catch towards you.
2. Loosen the locknut to make adjustment.
3. Rotate the catch clockwise or counter clockwise to
get proper adjustment.
4. Retighten locknut, assuring the catch is vertical.
5. Flip the rubber boot back into position.
The hinges can also be adjusted as follows:
1. Loosen the two 1/4-20 bolts on the top of the hinge
plate and the two bolts on the bottom hinge plate.
2. Apply pressure to the door on the corners to get the
proper seal. While pushing, tighten the bolts in place.
Figure 10