beautypg.com

Installation, Electrical connections – Blodgett CNVX-14E User Manual

Page 15

background image

11

Installation

Electrical Connections

ELECTRICaL CONNECTION
all Models
NOTE: Electrical connections must be performed by a

qualified installer only.

Before making any electrical connections to these appli-

ances, check that the power supply is adequate for the

voltage, amperage, and phase requirements stated on

the rating name plate mounted on the appliance.
The circuit breaker that is used to provide power to this

appliance must have a minimum of .076” (3mm) contact

spacing. The circuit breaker must meet all Local and Na-

tional installation standards.
All appliances must be installed in accordance with Local

or National Electrical codes.
A wiring schematic is located on the inside of the remove-

able side panel.
NOTE: Disconnect the power supply to the appliance

before servicing.

WaRNING!!

Improper installation may invalidate your war-

ranty.

Electric Models
A strain relief for the power supply cord is provided. The

installer must supply a cord that meets all Local and Na-

tional installation standards.
Gas Models
U.S. and Canadian Installations
A power cord (115V units only) is supplied with a plug at-

tached. Plug the power cord into the desired receptacle.
This oven model uses a variable frequency inverter drive.

Appliances that use variable frequency inverter drives

produce high frequency noise and require filters and

shielded motor cabling. This causes higher leakage cur-

rent toward Earth Ground. Especially, at the moment of

switching ON this can cause an inadvertent trip of the ap-

pliance’s ground fault interrupter (GFCI). Some GFCIs

are more sensitive than others. Blodgett has qualified

the Pass and Seymour brand, part number 2095, 20 A,

125 VAC, 60 Hz, specification grade GFCI duplex recep-

tacle as being immune to the variable frequency inverter

drive’s noise. Blodgett recommends using this specific

GFCI for this model oven.

WaRNING!!

If the supply cord is damaged, it must be re-

placed by a special cord or assembly available

from the manufacturer or its service agent.

This manual is related to the following products: