Blodgett BLCT - Manual (Page 45)

43
Maintenance
Cleaning & Preventative maintenance
Figure 32
WeeKLY CLeAninG
In addition to the daily cleaning, it is necessary to clean
the control filter and behind the fan guard on a weekly ba-
sis. This is necessary for proper functioning of the oven.
Scale will build up on the fan and heat source leading to
a less efficient oven.
Cleaning the Control Filter
NOTE: Not applicable on mini combi ovens.
The control filter is located below the control compart-
ment, in front of the spray hose.
1. To remove, pull down on the black knob on the left of
the filter.
2. Clean the filter with soap and water.
3. Reinstall the filter. Press up on the filter until the back
of the knob is inserted into the hole in the bottom of
the oven.
4. Push up on the center of the knob to expand the back
of the knob securing the filter.
Cleaning Behind the Fan Guard
1. Loosen the two screws and on the fan guard (or baf-
fle).
2. Swing the baffle forward.
3. Thoroughly spray cleaner onto the fan and heat
source. Place the oven in the steam mode for ap-
proximately 10 minutes.
4. After ten minutes, rinse the cleaner off. Return the fan
guard to the closed position. Rotate the two screws to
secure the fan guard.
PRevenTive mAinTenAnCe
The best preventive maintenance measures are the
proper initial installation of the equipment and a
program for cleaning the appliance routinely. The Oven/
Steamer requires no lubrication. Contact the factory, the
factory representative or a local Blodgett Combi service
company to perform maintenance and repairs should they
be required.