Blodgett BLCT - Manual (Page 36)

34
Maintenance
Cook to Perfection
The cook to perfection function helps recipes compen-
sate for temperature fluctuations. These can occur when
transitioning between recipes with different temperatures,
opening the door, or adding frozen products. The system
makes real time adjustments to cook time ensuring qual-
ity cooking.
CTP threshold (%)
CTP threshold accounts for when the cavity temperature
is below the recipe set temperature. Time will be added
to the recipe as long as the cavity temperature remains
below the CTP threshold percent of temperature.
EXAMPLE: The oven preheats to a recipe’s set tempera-
ture of 350°F and a frozen product is loaded. The temper-
ature of the frozen product and opening the door causes
the cavity temperature to drop to 230°F. The CTP will be-
gin extending the total recipe time as long as the cavity
temperature remains below the programmed threshold
value, at 80% this equates to 285°F. This compensates
for the time it takes the oven to recover to the 350°F
called for in the recipe.
CTP tolerance (°)
The CTP tolerance value is a temperature range. If the
oven’s measured temperature is outside the range of the
desired temperature, the unit will adjust cook times. Un-
like the threshold value, the tolerance compensates when
the oven is too high above set point as well as below set
point by adding or subtracting time as needed.
EXAMPLE: Using the same example of 350°F, a 15° tol-
erance means that time will be added to the recipe as
long as the cavity is lower than 335°F and subtract if cav-
ity achieves temperatures above 365°F. This may be the
case if you go from a recipe with a higher set temperature
to a lower temperature without allowing the oven to cool.
To set up Cook To Perfection (CTP)
1. From the MAIN MENU select the GEAR ICON.
2. Select SUPER USER from the SETTINGS MENU.
3. Select SETTINGS from the SUPER USER MENU.
4. Select COOK TO PERFECTION and set to YES to
enable.
5. Select CTP THRESHOLD. Enter the percentage of
set temperature you would like CTP to use for a tem-
perature threshold.
6. Select CTP TOLERANCE. Enter the temperature you
would like CTP to use for a temperature tolerance.
Figure 26