Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 49)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Expansion Module Notes
Displays basic expansion information.
Note - Expansion module ports cannot be enabled/disabled. Attempting to do so will
result in the error message: "The error occurred with 'Set' operation. Error: gen Error".
Note - The Port Speed and Mode parameter of the 100/1000Base-T port on the AT-A14
expansion module can only be set to 'auto'. Attempting to set this to any other value will
result in the error message: "The error occurred with 'Set' operation. Error: gen Error".
Note - A GBIC image is always visible on the GBIC slot of the AT-A15 expansion
module even if there is no GBIC physically inserted.
Note - The Port Speed and Mode parameter of the 1000Base-X port on the AT-A15
expansion module can only be set to '1Gbps full-duplex'. Attempting to set this to any
other value will result in the error message: "The error occurred with 'Set' operation.
Error: gen Error".
Note - The Port Speed and Mode parameter of the 100Base-FX port on the AT-A16, AT-
A17, and AT-A19 expansion modules can only be set to '100Mbps full-duplex'.
Attempting to set this to any other value will result in the error message: "The error
occurred with 'Set' operation. Error: gen Error".
AT-8324
PN 613-50665-00 Rev B Page 49 of 277