Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 148)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - Valid MIB Set values for the Port Back Pressure parameter are 'disable' and
'enable'. Attempting to set Port Back Pressure to 'unknown' will cause the parameter to be
set to 'enable'.
Note - The Port CoS/QoS Priority parameter is not applicable to the AT-8500 series and
should be ignored.
Note - AT-8550 : The current firmware version allows the Port Speed and Mode
parameter of a GBIC or SFP port to be set to '10Mbps full-duplex' or '100Mbps full-
duplex' even if the GBIC or SFP module inserted is not capable of 10/100 Mbps
connectivity.
Note - AT-8550 : The 10/100/1000Base-T twisted pair ports cannot be manually set to
1000Mbps. However, the current firmware version allows the Port Speed and Mode
parameter for these ports to be set to '1Gbps full-duplex' or '1Gbps half-duplex'.
Note - Setting the Port MDIO parameter to 'auto mdix' will cause the parameter to bet set
to 'mdi'.
CoS
Displays Class of Service parameters and allows you to configure CoS for a port, change
the default mappings of CoS priorites to egress priority queues and configure a
scheduling method for Class of Service.
Note - Valid MIB Set values for the Queue Weight parameters are in the range [1-255]
inclusive.
Note - Valid MIB Set values for the CoS Queue parameters are:
• egress-queue-0
• egress-queue-1
• egress-queue-2
• egress-queue-3
Attempting to set these parameters to any other value will result in the error message:
"The error occurred with 'Set' operation. Error: bad value."
Enable
Enables the port.
Disable
Disables the port.
Port Mirroring
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note - The current firmware version does not allow the Port Mirroring Status parameter
to be set to 'enabled' if, upon device startup, the Port Mirroring feature is disabled.
PN 613-50665-00 Rev B Page 148 of 277