Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 164)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
CoS
Displays Class of Service parameters and allows you to configure CoS for a port, change
the default mappings of CoS priorites to egress priority queues and configure a
scheduling method for Class of Service.
Note - When the priority level of a CoS Queue parameter is modified, what actually gets
modified is the priority level of the next higher priority queue. In addition, the priority
level is set to the next higher priority.
Note - The current firmware version does not allow the CoS Queue parameters to be set
to the following values:
• egress-queue-4
• egress-queue-5
• egress-queue-6
• egress-queue-7
Enable
Enables the port.
Disable
Disables the port.
Port Mirroring
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note - The current firmware version does not allow the Port Mirroring Status parameter
to be set to 'enabled' if, upon device startup, the Port Mirroring feature is disabled.
Note - The current firmware version does not allow the Mirroring Source Port (Ingress)
and Mirroring Source Port (Egress) parameters to be set to NULL.
Note - The current firmware version does not allow the Mirroring Destination Port
parameter to be set to 0.
Note - The Mirroring Source Module, Mirroring Source Port and Mirroring Destination
Module parameters are not applicable to the AT-9400 series and should be ignored.
MAC Address Security
Displays MAC Address Security parameters and allows you to set the security level for
dynamic and static MAC addresses learned and assigned to a port.
Note - The current firmware version allows the Security Threshold parameter to be set to
a value in the range [1-255] inclusive.
DoS Defense
Displays DoS Defense parameters and allows you to enable/disable a defense mechanism
on a port.
PN 613-50665-00 Rev B Page 164 of 277