Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 150)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Expansion Module Notes
Note - When adding/removing/changing an expansion module, AT-View Plus Device
Manager does not automatically refresh the device image in the main window to reflect
the addition/removal/change. To view the updated device image, click on the Refresh
option under the Agent menu.
Note - Configurable parameters under the Detail Info option cannot be modified for the
AT-A45 expansion modules. Attempting to do so will result in the error message: "The
error occurred with 'Set' operation. Error: gen Error."
Note - The AT-A45 expansion module ports cannot be enabled/disabled. Attempting to
do so will result in the error message: "The error occurred with 'Set' operation. Error: gen
Error."
Note - The AT-A46 expansion module port cannot be manually set to 1000Mbps.
However, the current firmware version allows the Port Speed and Mode parameter for
this port to be set to '1Gbps full-duplex' or '1Gbps half-duplex'
Note - The current firmware version allows the Port Speed and Mode parameter of the
AT-A47 expansion module port to be set to '10Mbps full-duplex' or '100Mbps full-
duplex' even if the GBIC installed is not capable of 10/100 Mbps connectivity.
Note - The Port Speed and Mode parameter of the AT-STACKM expansion module port
should have a fixed value of 'auto sense'. However, the current firmware version allows it
to be changed to '10Mbps full-duplex', '100Mbps full-duplex' or '1Gbps full-duplex'.
AT-8500 Series
PN 613-50665-00 Rev B Page 150 of 277