Agent menu – Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT User Manual
Page 23

Allied Telesyn
AT-VIEW PLUS
DEVICE MANAGEMENT
Note
- Setting the 'Active Protocol Version' to 'STP' and 'Spanning Tree Status' to 'enabled' will
set the Port State parameter of disabled ports to 'blocking'. As a result, port images for disabled
ports will turn yellow.
Note
- Setting the 'Active Protocol Version' to 'RSTP' and 'Spanning Tree Status' to 'enabled' will
set the Port State parameter of inactive ports and disabled ports to 'blocking'. As a result, port
images for inactive ports and disabled ports will turn yellow.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log into
the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Note
- Attempting to set the System Contact, System Name, and System Location
parameters to NULL will result in a general error. However, the parameters will still be
temporarily set to NULL. Once the switch is restarted, the original values will be
restored.
Note
- The current firmware version accepts up to 40 characters for the System Contact,
System Name and System Location parameters. However, specifying a value that is
exactly 40 characters in length will result in an error message. This error message may be
ignored as the value will still be set successfully.
Firmware Info
Displays firmware version.
Network Info
Displays network-related information such as the addresses of the default gateway and the
agents.
Note
- The current firmware version does not allow the Default Domain Name and the
DNS Server parameters to be configured.
Manager Address Info
Displays the IP address of the management station.
Device Info
Displays general information about the switch.
MAC Address Table
Displays a list of static MAC addresses configured on the switch.
Note
- MAC Address Table entries created through a local or telnet management session
will not be visible to AT-View Plus Device Manager until the device is restarted.
PN 613-50665-00 Rev B
Page 23 of 277