Voip menu – Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT User Manual
Page 264

Allied Telesyn
AT-VIEW PLUS
DEVICE MANAGEMENT
Group Info
Displays a list of all group multicast address.
Server Info
Displays a list of all multicast servers.
Note
- The Server Info sub-menu option does not display the correct parameters. Instead,
it displays the sub-menu option name as a parameter with a value of 'noSuchName'.
VoIP Menu
From the VoIP menu, you can view and edit information related to telephony services available
on the residential gateway.
Note
- The current firmware version does not provide the information needed by AT-View Plus
Device Manager to support the H.323 and SIP protocols.
Profile Info
Displays information related to admin profile.
DTMF Relay
Displays Dual Tone Multi-Frequency (DTMF) relay status.
Note
- AT-RG634A: It may take a while before the actual value for the Status parameter
is displayed. The value '???(0)(???(0))' may initially be displayed while Device Manager
is retrieving the actual value from the device.
Media
Displays information related to media transport.
Note
- AT-RG634A: The value displayed for the RTCP Status parameter is
'???(0)(???(0))'.
QoS
Displays Differentiated Service Code Point (DSCP) entries and its QoS priority level.
Note
- AT-RG634A: It may take a while before the actual values for DSCP and TOS
parameters are displayed. The value '0' may initially be displayed for both parameters
while Device Manager is retrieving the actual values from the device.
MGCP
Protocol Info
Displays general information about the protocol.
Note
- Valid MIB Set values for the Default Port parameter are in the range
[1024-2147483647] inclusive. Attempting to set this parameter to a value outside
the valid range will not result in an error but the new value will not be applied.
Note
- When setting the Profile parameter to 'none', the current firmware is able to
set the parameter successfully for the CLI but not for SNMP. As a result, AT-
View Plus Device Manager will continue to display the old value.
PN 613-50665-00 Rev B
Page 264 of 277