Allied Telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT - Manual (Page 163)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on the port,
bytes received and transmitted on the port, and port status.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and 'down'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - Setting the Port MDIO parameter to 'auto mdix' will cause the parameter to be set
to 'mdi'.
Note - The current firmware version (AT-S63 v1.0.0 NE) supports atiStackSwitch.mib
v2.9. However, AT-View Plus Device Manager supports atiStackSwitch.mib v2.10. As a
result, Port HOL Blocking and Port Admin State, which are parameters defined in v2.9
but not in v2.10, will appear as the Port HOL Limit and the Port STP State parameters
respectively.
Note - The current firmware version does not allow the Port Back Pressure Limit
parameter to be configured.
Note - Valid MIB Set values for the Port Flow Control parameter are 'disable' and
'enable'. Attempting to set Port Flow Control to 'unknown' will cause the parameter to be
set to 'enable'.
Note - Valid MIB Set values for the Port Back Pressure parameter are 'disable' and
'enable'. Attempting to set Port Back Pressure to 'unknown' will cause the parameter to be
set to 'enable'.
Note - The Port State and Port CoS/QoS Priority parameters are not applicable to the AT-
9400 series and should be ignored.
Spanning Tree Info
Displays the port's spanning tree parameters.
PN 613-50665-00 Rev B Page 163 of 277